User's Manual
Table Of Contents
- GMS-2 Operator’s Manual
- Table of Contents
- Preface
- Ch1: Introduction
- Ch2: Preparing the GMS-2 for Use
- Ch3: Using the GMS-2
- Ch4: Troubleshooting
- ApA: GMS-2 Software Reference
- ApB: Specifications
- ApC: Safety Warnings
- ApD: Regulatory Information
- APE: Warranty Terms
- Index
Troubleshooting
GMS-2 Operator’s Manual
4-2
Troubleshooting Quick List
To reset the software, see “Resetting the Software” on page 4-3.
To reset the hardware, see “Resetting the Hardware” on page 4-4.
For power problems:
If “The GMS-2 does not power up.” see page 4-5.
For general GMS-2 problems:
If “The GMS-2 is not receiving data (corrections) from an
external receiver.” see page 4-6.
If “Installed software and other data has been erased.” see
page 4-6.
For Bluetooth problems:
If “Cannot connect to a Bluetooth-enabled device.” see page 4-7.
If “The GMS-2 is no longer connected via Bluetooth.” see
page 4-7.
If “Cannot connect to a serial port device.” see page 4-8.
If “Cannot connect to a dial-up network service.” see page 4-8.