User's Manual
Table Of Contents
- GMS-2 Operator’s Manual
- Table of Contents
- Preface
- Ch1: Introduction
- Ch2: Preparing the GMS-2 for Use
- Ch3: Using the GMS-2
- Ch4: Troubleshooting
- ApA: GMS-2 Software Reference
- ApB: Specifications
- ApC: Safety Warnings
- ApD: Regulatory Information
- APE: Warranty Terms
- Index
Resetting the Software
P/N 7010-0752
4-3
Resetting the Software
Only perform a software reset in the following instances:
• To quit all active applications.
• After installing new applications.
• When an application is unresponsive.
To perform a software reset, use a pin or the end of a standard paper
clip to push in the software reset button (Figure 4-1).
Figure 4-1. Resetting the Software
Restoring BTManager and
Receiver Defaults
If the Bluetooth module or GPS receiver are not performing as
expected, try returning settings to defaults.
• For the Bluetooth module, tap Reset on the Accessibility tab in
BTManager.
• For the GPS receiver, tap Init on the GNSS tab in GMS Tools.