User's Manual
Table Of Contents
- GMS-2 Operator’s Manual
- Table of Contents
- Preface
- Ch1: Introduction
- Ch2: Preparing the GMS-2 for Use
- Ch3: Using the GMS-2
- Ch4: Troubleshooting
- ApA: GMS-2 Software Reference
- ApB: Specifications
- ApC: Safety Warnings
- ApD: Regulatory Information
- APE: Warranty Terms
- Index
BTManager
P/N 7010-0752
A-7
5. If desired, select “Exit on connect” to close BTManager but
remain connected to the internal GMS-2 Bluetooth module.
This allows other programs to open and use the port for
communicating with other Bluetooth-enabled devices.
6. Select a device to connect to and tap Connect.
Once a connection has been established, the Bluetooth Indicator turns
green (Figure A-5). The connection to the module will remain
established until you tap Disconnect, even if BTManager is closed.
• If a connection takes more than two minutes, tap Reset on the
Accessibility tab. Then try connecting to the device again.
• To view information on the connected device, double-tap the
device (Figure A-5).
• Selecting/deselecting “Master mode” will switch between Master
mode and Slave mode while connected.
• To disconnect from the device, tap Disconnect.
Figure A-5. Connected to Device and Device Properties
NOTICE
If “Exit on connect” is unchecked and BTManager
is closed, BTManager and the Bluetooth module
will remain connected, but the port used for
communication will be disconnected from the
module.
Other programs will not be able to use this port for
communicating with Bluetooth-enable devices.