User's Manual
Table Of Contents
- GMS-2 Operator’s Manual
- Table of Contents
- Preface
- Ch1: Introduction
- Ch2: Preparing the GMS-2 for Use
- Ch3: Using the GMS-2
- Ch4: Troubleshooting
- ApA: GMS-2 Software Reference
- ApB: Specifications
- ApC: Safety Warnings
- ApD: Regulatory Information
- APE: Warranty Terms
- Index
GMS-2 Software Reference
GMS-2 Operator’s Manual
A-8
Resetting the Bluetooth Module
Occasionally, the internal Bluetooth module may need to be reset to
ensure efficient detection/connection with other devices.
A reset of the module will occur after performing a software/
hardware reset or after tapping Reset in BTManager. A reset of the
module will return all settings to the defaults (including removing the
name and PIN information??). After a reset has occurred, check the
Accessibility tab in BTManager to enter/select the Bluetooth
module’s access information.
The Bluetooth module may need to be reset in the following
circumstances:
• If the search for available devices takes more than a couple
minutes.
• If a device connection takes more than a couple of minutes.
• When else??
To reset the internal GMS-2 Bluetooth module, open BTManager.
Once a connection to the module has been established, tap Reset on
the Accessibility tab.
Figure A-6. Reset Bluetooth Module
Reset
Bluetooth Module