User's Manual
Table Of Contents
- GMS-2 Operator’s Manual
- Table of Contents
- Preface
- Ch1: Introduction
- Ch2: Preparing the GMS-2 for Use
- Ch3: Using the GMS-2
- Ch4: Troubleshooting
- ApA: GMS-2 Software Reference
- ApB: Specifications
- ApC: Safety Warnings
- ApD: Regulatory Information
- APE: Warranty Terms
- Index
GMS-2 Software Reference
GMS-2 Operator’s Manual
A-14
Viewing GNSS Information and Logging Data
The GNSS tab displays current position and satellite information, as
well as applies certain settings to the internal GPS receiver.
• Position informaiton pane – displays the observation mode (No
Solution, Autonomous, or Code Differential), the number of
satellites being tracked, current time, current posistion (Lat/Lon/
Alt), and current PDOP.
• Antenna – selects the type of GPS antenna used, either the
internal GMS-2 antenna or an external antenna.
• Interval – the time interval for recording data. For example,
selecting 10 will record a position every 10 minutes.
• Elevation – the elevation mask for recording data from satellites
above the selected elevation (angle). For example, selecting 10
will have GMS Tools only record data from satellites that are 10°
above the horizon.
Figure A-11. View GNSS Information