User's Manual Part 1

Powering the Receiver

P/N 7010-0713

2-9

Charging Internal Batteries

Use one of the following conditions for maximum battery charge

speed:

• The receiver is turned off. Power Mode and Charger Mode are set

to Auto. See “Power Management” on page 2-5 for setting these

parameters.

• The receiver is turned on. Power Mode is set to External and

Charger Mode is set to Auto.

1. To charge the internal batteries:

• Plug the receiver-to-SAE power cable into the receiver’s

power input port.

• Connect the receiver-to-SAE power cable and the power

supply-to-outlet cable to the AC adapter.

• Plug the power supply-to-outlet cable into an available outlet.

2. Press the Reset key on the receiver. This will ensure that the

receiver is in Normal mode for charging. The receiver will not

charge in Zero Power Mode (see “Zero Power Mode” on page 4-

19 for more information).

3. Leave overnight. A seven-hour charge will charge the batteries

about 90%. A nine-hour charge will fully charge the receiver. The

internal batteries cannot be overcharged.

4. When finished charging, set the Power Mode to Auto.

NOTICE

If you remove a power supply cable before setting Power

Mode to Auto, the receiver will be turned off. To turn it on,

you will need to connect an external power supply once

again.