User's Manual Part 1

Configuration
HiPer XT Operator’s Manual
2-12
If you cannot establish a connection, check that the receiver’s slot
three is enabled.
1. Connect your receiver and a computer using an RS232 cable or
USB cable and PC-CDU as seen below.
2. Click ConfigurationReceiverGeneral.
3. In the Turn on/off Slots area, ensure the Slot 3 (B) check box is
enabled.
Establishing an RS232 Cable
Connection
1. Using the RS232 cable, connect the serial port of your computer
(usually COM1) to the receiver’s serial port A.
2. Press the power buttons on the receiver and computer to turn
them on.
3. Continue with Step 1 in “Establishing a PC-CDU Connection” on
page 2-13.
Establishing a USB Connection
Make sure the computer has the TPS USB driver installed.
1. Using the USB cable, connect the USB port of your computer to
the receiver’s USB port.
2. Press the power buttons on the receiver and computer to turn
them on.
3. Continue with Step 1 in “Establishing a PC-CDU Connection” on
page 2-13.