User's Manual Part 1

Configuration

HiPer XT Operator’s Manual

2-16

1. Connect your receiver and computer. See “Connecting the

Receiver and a Computer” on page 2-10 for this procedure.

2. Once connected, click ConfigurationReceiver (Figure 2-11).

3. Click the MINTER tab, configure the following settings, and

click Apply (Figure 2-11).

• Set the Recording interval in seconds.

• Set the Elevation mask for Log file in degrees.

• Enter the File name prefix. Use the last three digits of the

receiver serial number.The receiver’s serial number and part

number can be found on the bottom panel of the receiver.

Figure 2-11. Receiver Configuration – MINTER Tab

If your jobsite is in an area that has obstructions (buildings, trees,

etc.), and/or the antenna location is near reflective objects,

configure the receiver to reduce errors from these sources.

WARNING

Do not make other changes without consulting the

PC-CDU User’s Manual.