User's Manual Part 1

Configuration

HiPer XT Operator’s Manual

2-18

NOTICE

Disconnecting the receiver from the computer before

exiting will eliminate any possible conflict in the

management of your serial ports.

Once the receiver is configured, the configuration will remain until

you change it either using PC-CDU or clearing the NVRAM.

MINTER Configuration

The Minimum INTERface (MINTER) consists of three keys (Power,

FN, and Reset) and four LEDs (STAT, REC, BATT, and RX) that

control and display the receiver’s operation (Figure 2-14).

Figure 2-14. MINTER

The MINTER performs numerous functions:

• Turn the receiver on or off, put it in either Sleep mode or Zero

power mode.

• Turn data recording on or off (FN key).

• Change the receiver’s information mode.

• Show the number of GPS (green) satellites being tracked (STAT

led).

Power Button

Reset

BATT

(battery LED)

(modem status LED)

STAT (status LED)

FN (function/recording button)

REC (recording LED)