User's Manual Part 1

MINTER Configuration
P/N 7010-0713
2-19
• Show data recording status (REC led).
• Show each time data is recorded to internal memory (REC led).
• Show the status of post-processing mode (static or dynamic)
when performing a Post-Processing Kinematic survey with the
help of FN key (REC LED).
• Show the status (high charge, intermediate charge, or low charge)
of the battery (BATT LED).
• Show the power source for the receiver (BATT LED).
• Show the status of the modem and if it receives signals (RX
LED).
Use PC-CDU to configure MINTER settings. Refer to the PC-CDU
User’s Manual for other possible MINTER configurations.
1. Connect your receiver and computer. See “Connecting the
Receiver and a Computer” on page 2-10 for this procedure.
2. On the Connection Parameters dialog box, enable RTS/CTS
handshaking (Figure 2-15).
Figure 2-15. Connection Parameters – MINTER Settings
3. Click ConfigurationReceiver then click the MINTER tab, set
the following parameters and click Apply (Figure 2-16 on
page 2-20). See the following pages for descriptions of these
parameters:
• Recording interval on page 2-20