User's Manual Part 1

Configuration
HiPer XT Operator’s Manual
2-20
• Elevation mask for log file on page 2-20
• File name prefix on page 2-21
• Always append to the file on page 2-21
• Files Creation mode on page 2-21
• Automatic File Rotation Mode (AFRM) on page 2-21
• FN key mode on page 2-23
• Initial data collection dynamic mode on page 2-23
• Data recording auto-start on page 2-23
Figure 2-16. Receiver Configuration – MINTER Tab
Recording Interval parameter
This parameter specifies the message output interval into the log
file when the MINTER FN key (pressed for 1–5 seconds)
activates data logging. This setting is used for both logging a
single log file, and logging receiver data in AFRM mode. Values
are 1–86400 seconds.
The default value is one second.
Elevation Mask for Log File parameter
This parameter specifies the minimum elevation angle for the
satellites whose data will be put in the receiver files logged when
pressing FN.
The default value is five degrees.