User's Manual Part 1

Configuration
HiPer XT Operator’s Manual
2-30
9. From the Output Power control, select the level of RF transmit
power from 10 mW to 2 W.
Figure 2-20. Radio Link Tab
10. Click the Serial Interface tab and select a baud rate for the
modem’s serial port. The same rate must be used for both the
receiver and the modem.
Figure 2-21. Serial Interface Tab
11. Click Apply, then click on File and select Disconnect. If you
want to close the program, click File->Exit.
12. Launch PC-CDU and set up the receiver to run as an RTK Base
Station. For how to set up an RTK Base using PC-CDU, refere to
your receiver’s documentation or PC-CDU User’s Manual.