User's Manual Part 1

Configuration
HiPer XT Operator’s Manual
2-34
14. Click the Serial Interface tab and select a baud rate for the
modem’s serial port. The same rate must be used for both the
receiver and the modem.
15. Click Apply, then click on File and select Disconnect. If you
want to close the program, click FileExit.
16. Launch PC-CDU and set up the receiver to run as an RTK Base
Station. For how to set up an RTK Base using PC-CDU, refere to
your receiver’s documentation or PC-CDU User’s Manual.
Configuring a Rover Station’s UHF
Radio Modem
NOTICE
NOTICE
To comply with RF exposure requirements, maintain at
least 25cm between the user and the TPS UHF radio
modem.
Repeat steps 1-4 from page 2-27.
When finished configuring the radio modem, always disconnect from
Modem-TPS before exiting to prevent conflicts with serial port
management.
There are two scenarios for configuring the radio-modem:
• With a dedicated channel.
• With the FCS mode.
Set Radio Link Parameters for a Dedicated
Channel
1. From the Protocol control, select between TPS and PDL.
• TPS – Select this protocol if all of the radio-modems at your
jobsite are manufactured by Topcon Positioning Systems.
• PDL – Select this protocol if you use PDL radio-modem(s)
together with TPS radio-modem(s) at the jobsite.