User's Manual Part 1

Configuration
HiPer XT Operator’s Manual
2-36
ensure reliable radio communication between the base
and rover receivers.
7. From the Protocol Mode control, select the appropriate link
protocol among the following available:
• Transparent w/EOT Character
• Transparent w/EOT Timeout
•Fast Async
Use the same protocol as at the base station.
8. From the Output Power control, set the level of RF transmit
power to 10 mW.
Figure 2-23. Radio Link Tab
9. Click the Serial Interface tab and select a baud rate for the
modem’s serial port. The same rate must be used for both the
receiver and the modem.
10. Click Apply, then click on File and select Disconnect. If you
want to close the program, click FileExit.
11. Launch PC-CDU and set up the receiver to run as an RTK Rover
Station. For how to set up an RTK Rover using PC-CDU, refere
to your receiver’s documentation or PC-CDU User’s Manual.