User's Manual Part 1

Radio Configuration

P/N 7010-0713

2-39

13. In the Time Out edit box, specify a period of time in seconds

within which the rover radio-modem will listen to the incoming

data on the current operating frequency. Should there be no any

data detected during the specified amount of time, the rover will

switch to the next frequency in the list and so forth until the

frequency with data is found.

NOTICE

It is recommended to make this parameter greater than the

base radio-modem’s Time out by 2 to 3 seconds.

Figure 2-24. FCS Tab

14. Click the Serial Interface tab and select a baud rate for the

modem’s serial port. The same rate must be used for both the

receiver and the modem.

15. Click Apply, then click on File and select Disconnect. If you

want to close the program, click FileExit.

Launch PC-CDU and set up the receiver to run as an RTK Rover

Station. For how to set up an RTK Rover using PC-CDU, refere to

your receiver’s documentation or the PC-CDU User’s Manual.