User's Manual Part 1

Radio Configuration
P/N 7010-0713
2-41
Figure 2-25. GSM Tab
7. Click the Serial Interface tab and select a baud rate for the
modem’s serial port. The same rate must be used for both the
receiver and the modem.
8. Click Apply, then click on File and select Disconnect. If you
want to close the program, click File->Exit.
9. Launch PC-CDU and set up the receiver to run as an RTK Base
Station. For how to set up an RTK Base using PC-CDU, refere to
your receiver’s documentation or PC-CDU User’s Manual.
Configuring a Rover Station’s GSM
Module with Modem-TPS
NOTICE
NOTICE
To comply with RF exposure requirements, maintain at
least 25cm between the user and the GSM radio modem.
1. Repeat steps 1-4 from page 2-27.
When finished configuring the GSM module, always disconnect
from Modem-TPS before exiting to prevent conflicts with serial
port management.
2. Click the GSM tab.
3. In the Mode control, select Master.