User's Manual Part 1

Configuration
HiPer XT Operator’s Manual
2-42
4. In the PIN field, enter a Personal Identification Number (PIN) if
required.
5. In the Dial field, enter the phone number of the base GSM
modem.
6. In the Send time field, enter a period of time in seconds with
which the rover GSM modem will send a service word to the base
GSM modem. This parameter is used to maintain reliable
communication between the pair of modems and avoid
unnecessary modem reinitialization.
NOTICE
NOTICE
If both of your receivers are HiPer XT with internal GSM
modems, set Send time to zero.
Figure 2-26. GSM Tab
7. Click the Serial Interface tab and select a baud rate for the
modem’s serial port. The same rate must be used for both the
receiver and the modem.
8. Click Apply, then click on File and select Disconnect. If you
want to close the program, click File->Exit.
9. Launch PC-CDU and set up the receiver to run as an RTK Rover
Station. For how to set up an RTK Rover using PC-CDU, refer to
your receiver’s documentation or the PC-CDU User’s Manual.