User's Manual Part 1

Setup and Survey
HiPer XT Operator’s Manual
3-10
3. Check the STAT light for tracked satellites.
4. Connect your receiver and computer. See “Connecting the
Receiver and a Computer” on page 2-10 for this procedure.
5. Click ConfigurationReceiver.
6. Click Set all parameters to defaults (Figure 3-6).
Figure 3-6. Set All Parameters to Defaults
7. On the Receiver Configuration screen, click the MINTER tab and
specify the desired settings. Refer to the PC-CDU User’s Manual
for more information.
8. Click the Positioning tab and set the Elevation mask parameter to
15 (Figure 3-7), then click Apply.
Figure 3-7. Configure Receiver Positioning – Elevation Mask