User's Manual Part 1

Surveying with the Receiver

P/N 7010-0713

3-11

9. Select the Base tab, set the following parameters (Figure 3-8),

and click Apply:

• GPS/GLO at one time – enable

• Antenna position – enter Lat, Lon, and Alt values. Do one of

the following:

– If known, type in the values.

– Enable Averaged and enter the Averaged Span in seconds,

then click Apply. Click ToolsReset receiver and wait

until the specified interval (span) completes. Examine the

Base coordinates on the Base tab, they should correspond

to the coordinates obtained from the average. Click

Refresh if the coordinates are zeros.

– Click Get from receiver.

NOTICE

The reference geodetic coordinates specified on this tab

relate to the antenna L1 phase center.

Figure 3-8. Base Configuration