User's Manual Part 1

Surveying with the Receiver
P/N 7010-0713
3-13
Set up an RTK Rover
Use the following steps to set up an RTK Rover station. You should
already have programmed the modem.
Figure 3-10 shows the hardware setup for a Rover station with an
external controller.
Figure 3-10. Rover Station Setup
1. Set up the Rover station receiver’s antenna as described in
“Receiver Setup” on page 3-1.
2. Connect the receiver and computer. See “Connecting the Receiver
and a Computer” on page 2-10.
3. Click ConfigurationReceiver.
4. Click the Positioning tab and set the Position Masks, Elevation
mask (degrees) parameter to 15 (Figure 3-7 on page 3-10).