User's Manual

Getting Acquainted
P/N 7010-0816
1-9
The Reset button causes a hard reset of the receiver and causes the
receiver to leave Zero Power Mode and return to Normal Mode.
The Power button turns the receiver on and off.
The Battery LEDs display the power status for each battery:
• Green – indicates greater than 85% charge.
• Orange – indicates an intermediate charge.
• Red – indicates less than 15% charge.
The pattern of blinks also indicates the source of power:
• Solid light – an external power supply is used, and the batteries
are not being charged.
• Blinking once a second – the batteries are being charged.
• Blinking once every five seconds – the receiver uses the internal
batteries for power.
• Not blinking – the receiver is in Zero Power Mode or the internal
batteries are discharged, and no external power is connected.
The STAT LED displays the status of tracked satellites.
• Red blink – receiver is on but is not tracking satellites or does not
have a solution.
• Green blink – receiver is on and tracking satellites; one blink per
tracked GPS satellite.
• Orange blink – receiver is on and tracking satellites; one blink per
tracked GLONASS satellite.
NOTICE
Only use this procedure if the receiver does not
respond to commands or does not charge the
internal batteries (is in Zero Power Mode).
NOTICE
When the internal batteries have completely
discharged and no external power is connected, the
receiver goes into Zero Power Mode to prevent the
batteries from over discharging.