User's Manual

P/N 7010-0816
Chapter 2
2-1
Pre-survey
Preparation
Before beginning to survey with the HiPer Ga/Gb receiver, the
following software needs to be installed and configurations need to be
applied:
 Install receiver configuration software
See “Installing Topcon Software” on page 2-2.
 Charge the batteries
See “Charging the Internal Batteries” on page 2-7.
 Enable power source settings (either attached or external)
See “Power Management” on page 2-9 and “Powering the
Receiver with an External Battery” on page 2-13.
 Configure the Bluetooth wireless technology module
See “Bluetooth Module Configuration” on page 2-17.
 Collect almanacs and ephemerides (after first-time configuration
activities as described on page 2-21).
See “Collecting Almanacs and Ephemerides” on page 2-21.
This chapter also discusses connecting batteries to the receiver,
connecting the receiver and a computer, and powering the receiver
using different sources.