User's Manual

Pre-survey Preparation
HiPer Ga/Gb Operator’s Manual
2-8
3. Connect the power adapter cable to power port on the receiver.
4. Plug the power supply into an available outlet.
5. Press the Reset key on the receiver to ensure it is in Normal mode
for charging. The receiver will not charge in Zero Power mode.
6. Leave overnight.
A nine-hour charge will charge the batteries about 90 percent. A
ten-hour charge will fully charge the receiver. The internal
batteries cannot be overcharged.
The speed of the charge depends on the Power and Charger settings
configured using PC-CDU and whether the receiver is turned off or
on. See “Power Management” on page 2-9 for more information. For
maximum battery charging speed, use one of the following
conditions:
• The receiver is turned off. Power Mode and Charger Mode are set
to Auto.
• The receiver is turned on. Power Mode is set to External and
Charger Mode is set to Auto.
CAUTION
Use a grounded wall outlet or grounded surge
protector while charging.