User's Manual

HiPer Ga/Gb Receiver Setup and Survey
HiPer Ga/Gb Operator’s Manual
4-2
To set up the Base receiver (Figure 4-1):
1. Install a tripod over a known control point, and secure the
universal tribrach to the tripod.
2. Place the tribrach adapter (either universal or precision) on the
tribrach, and tighten the screws.
3. Insert the L-plug (horizontal spacer) into the tribrach adapter.
4. Attach the HiPer Ga/Gb receiver to the L-plug (horizontal
spacer).
5. Attach the radio antenna to the antenna connector (for RTK only).
6. Carefully level the tripod and tighten the screws.
7. Attach any other accessories as needed (for example, a backup
power supply).
Figure 4-1. Install Tripod and Receiver over Control Point
HiPer Ga/Gb Receiver
Horizontal Spacer
Tribrach Adapter (Precision)
Universal Tribrach