User's Manual

Tilt detection function
Switching the tilt direction
The tilt direction can be changed.
1 Long-push the detective precision switch and the tilt switch at the
same time. The tilt direction mode setting changes in the following
order: "Back and Forth," "OFF" and "Right and Left." At this time, the
LED at the side of the mark indicating the tilt direction will flash. The
LED will not flash when the tilt detection function is switched OFF.
Switching the tilt precision
1 Short-push the tilt switch. The tilt precision will change. At this time,
the LED at the side of the mark indicating the tilt precision will light up.
Zero position setting for the tilt sensor
Before using the tilt detection function, set the zero position of the tilt sensor
according to the directions below. The tilt direction must be set before set-
ting the zero position.
1 Raise or lower the machine blade or arm where the LS-B110/LS-
B110W is installed to position the cutting edge or bucket at the
desired slope.
2 Long-push the tilt switch. The tilt angle for the LS-B110/LS-B110W
will set to 0º.
To set the vertical zero position of tilt sensor to perpendicular.
1 Vertically position the machine blade or arm where the LS-B110/
LS-B110 is installed.
2 Rotate the LS-B110/LS-B110W on the pole each by 90º, and
confirm that the green LED in the tilt indicator is flashing in all
directions.
3 Set the zero position.
Tilt angles and display patterns
Tilt directions : Right and Left
Tilt directions : Back and Forth
Changing the ON-GRADE position function
The ON-GRADE position can be changed to the position where laser beam
is detected. Using this function when installing the LS-B110/LS-B110W on
the pole of the machine allows easy setting of the height at which the ON-
GRADE will be displayed on the LS-B110/LS-B110W. The range in which
the ON-GRADE position can be changed is ±75mm (total of 150mm) from
the center of the detective range.
1 Long-push the zero-set switch while detecting the laser beam.
The LED display while changing the ON-GRADE position
The LED display indicating beam position and the LED (1 green) in the cen-
ter will flash.
Canceling the ON-GRADE position change
1 Long-push the zero-set switch when not detecting the laser beam.
The ON-GRADE position will be reset.
Tilt direction mark : Right and LeftTilt direction mark : Back and Forth
Tilt precision mark : High precision
Tilt precision mark : Normal precision
The LED lights up as shown in the figure for three sec-
onds when the zero position is set.
The LED flashes as shown in the figure for three sec-
onds when you have failed to set the zero position.
High precision : ±1°
Normal precision : ±2.5°
Flashes quickly
±5
°
More than ±5°
Flashes slowly
Lights off
High precision : ±1
°
Normal precision : ±2.5°
High precision : More than ±1°
Normal precision : More than ±2.5°
Tilt indication will be displayed during laser detection and for 20
seconds after switch operation.
When changing the ON-GRADE position, the LED
lights up for three seconds, as shown in the figure. The
position where the laser beam is being detected will be
the ON-GRADE position.
The LED lights up as shown in the figure for three sec-
onds when you have failed to change the ON-GRADE
position. Be careful not to change the position at which
the laser beam is detected and try setting once again.
When the ON-GRADE position change is cancelled,
the LED (3 green) will flash for three seconds.