Installation Guide

Amuer Installation

The following codes can be installed as per the same way as this instruction.

FF002 FF020 FF041

FF003 FF021 FF042

FF004 FF022 FF043

FF005 FF023 FF044

FF006 FF024 FF045

FF007 FF025 FF046

FF008 FF026 FF047

FF009 FF027 FF048

FF010 FF028 FF049

FF011 FF029 FF050

FF012 FF033 FF051

FF013 FF034 FF052

FF014 FF035 FF053

FF015 FF036 FF054

FF016 FF037 FF055

FF017 FF038 FF056

FF018 FF040 FF057

For easy installation of your faucet, please ensure the following:

Read thoroughly all the instructions before installing the faucet.

Read and understand all warnings

Check all the components in the package.

PLEASE CAREFULLY READ THIS INSTRUCTIONS MANUAL BEFORE INSTALLING AND USING

THE PRODUCT.

PLEASE KEEP THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE REGARDING PRODUCT

OPERATION AND MAINTENANCE.

Attention: Before you install the faucet,

）

Please make sure the direction of the faucet should face to.

2) Please divided the hot water and cold water.

3) Please make sure you shut off the water supply.

Tools you may need.

Electric drill

Safety goggles

Adjusttable wrench

Pliers

Srewdriver

Pencil

PAGE 1
Amuer Installation The following codes can be installed as per the same way as this instruction.
PAGE 2
Cleaning and Care Care should be exercised when cleaning this product. Although its finish is durable, it can be damaged from harsh abrasives and cleaning pads. To clean, use light, non-abrasive cleaning solution or cleaning polish.
PAGE 3
Installation steps 1 Place the escutcheon (#4) over the standpipe (#3) and push it to the base, then turn the parmanent . seat to standpipe 2 Ture the inlet supplies to mixer, verify the hot one with red line and the cold one with the blue line.
PAGE 4
3 Making sure the prongs on the top of standpipe (#3), insert into the hole of the mixer (#2). Install the set and tighten into the standpipe (#3) 4 Mark the locations for the screws with a pencil. With an electric drill , drill three holes for the expansion screws (#8) in the floor. Place the expansion screw (#8) into the holes. Connect the flexible supply lines (#5) to the water supplies.
PAGE 5
Ensure the standpipe (#3) sits flush against the finished floor surface. Then secure the standpipe(#3) using screws (#8). Push the escutcheon (#4) over the standpipe (#3) base so that it sits flush against the finished floor surface. 6 Connect one end of the shower hose (#7) to the mixer (#2) and the other end to the showerhead (#9). Ensure the washer is placed into each end for seal.