User's Manual

2.16 A/F Reset

This function is applied to set or learn air/fuel rate parameters.

2.17 EGR Adaption

This function is used to learn the EGR (Exhaust Gas Recirculation)

valve after it is cleaned or replaced.

2.18 AC System Relearn/Initialization

AC system relearn/initialization must be performed when the vehicle

AC ECU or actuator is replaced or the ECU memory is lost.

2.19 AdBlue Reset

After the diesel exhaust treatment uid (car urea) is replaced or lled

up, urea reset operation is required.

2.20 Coolant Bleed

Use this function to activate the electronic water pump before venting

the cooling system.

2.21 Engine Power Balance Monitoring

This function is used to monitor crankshaft acceleration in the power

stroke of each cylinder, to determine the relative power provided by

each cylinder.

2.22 High Voltage Battery Detection (HIGH VOLTAGE BATTERY)

This function is used for high voltage battery diagnosis and status

information detection.

2.23 Language Change

This function is used to change system language of vehicle center

console.

2.24 NOx Sensor Reset

NOx sensor is a sensor used to detect the content of nitrogen oxides

(NOx) in engine exhaust. If the NOx fault is re-initialized and the NOx

catalytic converter is replaced, it is necessary to reset the catalytic

converter learned value stored in the engine ECU.

2.25 Stop/Start Reset

This function is used to open or close the automatic Start/Stop

function via setting the hidden function in ECU (The precondition is

vehicle equipped with hidden function and hardware support).