User's Manual

EN
33
Q: System halts when reading the data stream. What is the reason?
A: It may be caused by a slackened connector. Please turn off the
tablet, rmly connect the connector, and switch it on again.
Q: Screen ashes at engine ignition start.
A: Normally caused by an electromagnetic disturbance.
Q: There is no response when communicating with the on-board
computer.
A: Please conrm the proper voltage of the power supply and check
the following:
•
Whether the throttle has been closed;
•
Whether the transmission is in the proper position;
•
Whether the water is the proper temperature.
Q: What to do if the system fails to start auto VIN detection?
A: Please check the following possible causes:
•
Whether the tool is properly connected to the vehicle’s DLC.
•
Whether the “Automatic detection on Connect” switch is OFF. If yes,
slide it to ON.
Q: Why are there so many fault codes?
A: Usually it’s caused by a poor connection or fault circuit grounding.
Q: How to upgrade the system software?
A:
1. Power the tool on and ensure a stable internet connection.
2. Tap “Settings” on the Home Menu, select “About” -> “Version”, and
tap “Detect the System Version” to enter the system upgrading
page.
3. Follow the on-screen instructions step by step to nish the process.
It may take a while to nish the upgrade depending on the
internet speed. The tool will automatically restart and enters the
Home Menu when the upgrade is nished.
Q: What if the tablet cannot be turned on even after recharging?
A: Please charge the tablet for at least 3 hours until the power LED
lights up.
FAQ