User guide

3.1 Searching for broadcasting services 23
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the Search Mode option to Auto.
3. If you set the Network Search option to On, the digital
receiver will check up the up-to-date channel informa-
tion while searching services, but it takes a rather longer
time.
With the Auto mode, the digital receiver tries to search every
service, relying on the transponder data which is stored at the
time of manufacture. It thus may happen to fail to search all ac-
tually available services since services are more often than not
launched, discontinued, or removed into another transponder.
To avoid such missing, you had better set the Search Mode
item to Blind. With the Blind mode, the digital receiver tries
to search every service, scrutinizing every transponder with
every possible combination of transponder elements. It thus
may require many minutes or even many hours.
It is possible to search several satellites one after another for
services. Set the Multi Sat Mode item to Multi, then the Satel-
lite Name item becomes disabled and the Satellite List item be-
comes enabled. Pressing the




OK button at the Satellite List
item pops up the list of satellites. Select satellites you want
to search and exit with the




EXIT button.
Searching every service of a transponder
To search every service of a transponder, take the following
steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the Search Mode option to Manual, and then press
the




OK button to diaply additional options.
3. Choose your desired transponder at the Frequency op-
tion or enter it with the numeric buttons.