User guide

3.1 Searching for broadcasting services 25
6. Set the Modulation option to match to that of your de-
sired transponder. If the transponder is of the DVB-S2
standard, you should set this option to DVB-S2 QPSK or
DVB-S2 8PSK. Then the FEC option and the Pilot option
will become enabled. You also should set these options
correctly.
7. At the PID option, specify the audio and video packet
identification (PID) of your desired service with the nu-
meric buttons.
Searching every service of SMATV system
To search every service of a SMATV system, if the digital re-
ceiver is connected to it, take the following steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the Search Mode option to SMATV, and then press
the




OK button to diaply additional options.
3. Choose your desired transponder at the Frequency op-
tion or enter it with the numeric buttons.
4. Enter the symbol rate of your desired transponder to the
Symbol Rate option with the numeric buttons.
You can search pay services as well as free services as follows:
• To search only free services, set the FTA/Scrambled op-
tion to FTA only.
• To search only pay services, set it to CAS only.
• To search both free services and pay services, set it to FTA
+ CAS.
To start service search, move down to the Start Search item,
and press the




OK button. The digital receiver will start to
search for services and display a list of television and radio
services as they are found. It is common for no channels to be
found until quite late in the process. When the scan is com-
plete, you will see a message telling you how many services
have been found. Press the




OK button to save the list.