Operation Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Setup
- 3 Service Search
- 4 Preference Settings
- 5 Every Day Use
- 6 Organising Services
- 7 Recording and Playback
- 8 Entertainment
- 9 Accessing via Network
- 10 Firmware Update
- A Universal Remote Control
- Index
4
4.10 Options for standby mode 47
4.10 Options for standby mode
You can have the current time displayed on the front display
in standby mode. Select the Settings > Miscellaneous menu
and set the Standby Mode option to Active; otherwise, set it
to Passive. When you set the Standby Mode option to Active,
the receiver can also bypass the signal from the antenna. To
save power consumption, you might as well set the Automatic
Power Down option to Enable. With this option enabled, the
receiver will be turned off automatically when there is no ma-
nipulation over three hours.