User guide

3.1 Searching for broadcasting services 27

3. Choose your desired transponder at the Frequency op-

tion or enter it with the numeric buttons.

4. Enter the symbol rate of your desired transponder to the

Symbol Rate option with the numeric buttons.

5. Set the Polarization option to match to that of your de-

sired transponder.

6. Set the Modulation option to match to that of your de-

sired transponder. If the transponder is of the DVB-S2

standard, you should set this option to DVB-S2 QPSK or

DVB-S2 8PSK. Then the FEC option and the Pilot option

will become enabled. You also should set these options

correctly.

7. At the PID option, specify the audio and video packet

identiﬁcation (PID) of your desired service with the nu-

meric buttons.

Searching every service of SMATV system

To search every service of a SMATV system, if the digital re-

ceiver is connected to it, take the following steps:

1. Choose your desired satellite at the Satellite Name op-

tion.

2. Set the Search Mode option to SMATV.

3. Choose your desired transponder at the Frequency op-

tion or enter it with the numeric buttons.

4. Enter the symbol rate of your desired transponder to the

Symbol Rate option with the numeric buttons.

You can search pay services as well as free services as follows:

• To search only free services, set the FTA/Scrambled op-

tion to FTA only.

• To search only pay services, set it to CAS only.

• To search both free services and pay services, set it to FTA

+ CAS.

To start service search, move down to the Start Search item,

and press the









OK button. The digital receiver will start to