User Manual
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS
FCC RF Exposure Information and Statement
This device meets the government's requirements for exposure to radio waves.
The guidelines are based on standards that were developed by independent scientic
organizations through periodic and thorough evaluation of scientic studies. The standards
include a substantial safety margin designed to assure the safety of all persons regardless
of age or health. The SAR limit of USA (FCC) is 1.6 W/kg averaged.
Device types: portable device has also been tested against this SAR limit. SAR information
on this and other pad can be viewed on‐line at http://www.fcc.gov/oet/ea/fccid/.
Please use the device FCC ID number for search.
This device was tested simulation typical 0mm to body.
To maintain compliance with FCC RF exposure requirements, use accessories should maintain
a separation distance between the user's bodies mentioned above.
FCC Warning
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference
that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modications to this unit not expressly approved
by the party responsible for compliance could void the user's authority to operate the equipment.
CE
The product shall only be connected to a USB interface of version USB2.0
and that the connection to a power USB is allowed.
Use careful with the earphone maybe possible excessive sound pressure from earphones
and headphones can cause hearing loss.
SAFETY AND REGULATORY COMPLIANCE
P.16