Operation Manual

19
the AC adapter until the battery is fully charged. The
right indicator lamp on the front edge of the notebook
will stop flashing when the notebook is fully charged.
Warning:
The description below applies to
notebooks that have been pre-installed with an OEM
version of Windows 95 or Windows 98. If your system
has not been pre-installed with an OEM Windows,
install your own operating system using retail versions
of the operating system software and following the
instructions given with the software.
The installation is completed when you turn on the computer for the
first time. At that point, Windows will run a setup program which
gathers important information about you and your computer
preferences, so that Windows operates the way you want it to.
Throughout the setup procedure, Windows will present dialog boxes on
the screen. When you have read the dialog box and wish to proceed
with the installation, use the touchpad to point to the Next button and
then click it. If you wish to review a part of the installation procedure,
click on the Back button.
1. Turn on your notebook by pressing the power switch down and
holding it down for about one to two seconds.
2. When Windows starts, you may see a Safe Recovery message.
This means that the notebook has been turned on at least once
since the partial installation of Windows, and Windows has
registered the fact that the final installation was not completed at
that time. You can ignore the safe recovery message and proceed.
3. The setup program will ask for the language and layout of your
keyboard. Select the appropriate items from the list provided and
proceed.
4. Setup will then ask for your name and company name if applicable.
Type in the information and proceed.
5. Setup will then display the Windows license agreement. This
document details the terms and condition under which you are
licensed to use the Windows software. You must read this