Operation Manual

to an angle of about 20 degrees. You can then slide the module out

of the SODIMM socket.

6. Hold the new module at the same angle as the socket and slide the

edge connector side of the module into the socket. The edge

connector has a cut-out and the socket has a notch so that it can

only be installed in the correct way. Press the module into the

socket until you can no longer see the gold-teeth of the edge

connector.

7. Press the module down into the memory compartment so that the

locking latches on either side of the socket engage, and hold the

card down flat inside the compartment.

8. Replace the memory compartment cover and secure it with the

locking screw.

Insert Module

Press latches outwards

to release module