Operation Manual

66
Leave all electronic components inside their static-proof
packaging until they are required for the installation.
Handle all circuit boards and electronic components carefully.
Hold boards by the edges only. Do not flex or stress circuit
boards.
3. Locate the memory compartment cover and remove the locking
screw. Use a narrow-bladed screwdriver to pry the cover out of the
base by levering the cover upward.
4. Inside the memory compartment, you will see two sockets for the
SODIMMs. In some configurations of this notebook, one of the
socket will be occupied by a 32MB module. You can install another
SODIMM into the second socket. You can install any size of
SODIMM from 16 MB up to 128 MB in any of the free sockets.
5. If both sockets are occupied by SODIMMs, and you want to change
one or both of the SODIMMs for a higher capacity module, locate
the locking latches at each side of the socket. Pull these locking
latches outwards. This will allow the socket and module to pop up
Memory
Compartment
Locking Screw