Specifications

FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
and your body.
This module meets the requirements of FCC part 15C(15.407).it specifically establish the Bandwidth,
Output Power, Radiated Spurious Emission, Power Spectral Density, Restricted Band of Operation and
Band Edge, Out of Band Emissions. It is U.FL connect to the antenna, antenna gain 3dBi, antenna gain
tolerance:0.5dB
The antenna cannot be removed , Unconventional interface, The module with trace antenna designs, and
This manual has been shown the layout of trace design, antenna, connectors, and isolation requirements.
This module It’s complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This module is designed to comply with the FCC
statement, FCC ID is: ZLJTOP-AR1021.
The host system using this module, should have label in a visible area indicated the following texts:
"Contains FCC ID: ZLJTOP-AR1021.
TOPLINKST TECHNOLOGY COMPANY LIMITED can increase the utility of our modular transmitters by
providing instructions that simulates or characterizes a connection by enabling a transmitter.
The module without unintentional-radiator digital circuity, so the module does not require an evaluation
by FCC Part 15 Subpart B. The host shoule be evaluated by the FCC Subpart B.