User Manual

≥45mm(Cylinder will be specially made)
21
20
InstallationandAdjustment
35
110
1、 Drill a large and a small
hole on the door for the
front and rear panel and
drill a round hole on the
door frame for the deadbolt
according to the 1:1 template.
2、 Insert the deadbolt into
the hole of the door frame
and fix it with 2 screws.
3~4、 Insert the thin bar of the
front panel into the hole
of the deadbolt in a vertical
status, and then put the
cable wir e of th e fr ont
panel through the door
hole to the inside of the door.
5、 Pass the cablewire through
the small square hole on
the right side of the
mounting plate, and then
fix the mounting plate
and the front panel with
3 screws.
6、 Remove the battery cover.
If the lock is for right-open,
keep the knob in the vertical
direction and the moving
switch in PCB is in R position.
(If the lock is for left-open,
keep the knob in horizontal
position, the moving switch
in PCB is in the L position)
step1 step2
step3 step4
step5 step6