User Manual

DLM808 can connect with PC by internet

port on router, or by CL-4. After successfully

connected, please click the file named

MatrixPro.exe on PC, you can see initial page

as below picture shows, which can set

connection of each device.

1. Configuration of IP Address

When connect DLM808 with PC by internet port on router:

Before connect devices on software control page, please set IP

address of DLM808 and router first, below gives steps(pay

attention that the toggle switch on DLM808 rear panel should be

at LAN side):

1). Click “Connect” control on top right corner, a search dialog will

jump up, click “Scan” button, it will automatically search IP and

MAC address in the system, as below picture shows. Then click

“Connect” button to build communication. The “Status” control in

top right corner indicates the communication status, which will

light green if connect right, while off means fail to connect.

2). If fail to connect following above step, then please key the IP address in “Choose IP” text field,

then click “Connect” button. After connecting successfully, you can see device information in the

lower-left corner, as below picture shows.

2. Configuration of Device Connection on Initial Page

Below picture shows you the connected status between CL-4 and DLM808.

How to connect?

1). Add Device

Hold to click CL-4(or Lan Interface) under

“Config DeviceList” and drag it to the

middle area, then release mouse, the CL-4

will be added to this area, use the same way

to add other devices.

2). Delete Device

Right-click the device, select “Delete

Module” to delete it.

Note: Before delete the device, please make sure that all the lines that connected to the selected

device have been removed, or you may fail to delete it.

3). Configuration of Device ID

Right-click the device, select “Change DeviceID” , a dialog appears

as below picture shows,input a new Device ID in the text field,

then click “OK” button to change it.

Note: The new ID you key in must be the same as it is showing on

DLM808’s LCD screen.

After successfully connected devices, double click DLM808 on this initial page to enter DSP

control page, which will be introduced later.

DSP Control