User Manual

Control
12. 48V Phantom button
Every microphone input equips with an individual phantom power which is controlled by the 48V
phantom power button. When you want to turn on phantom power of some channel, the screen
will show warning to ask you and make sure. It will illuminate when phantom power is activated.
Please notice that only the condenser microphone needs phantom power.
Note: Please do not supply phantom power to any device which do not need phantom power
otherwise the device and T2208 may be damaged.
13. System/Routing button
Press this button twice, it will switch between System and Routing function.
˙System
Press this button to go to System page, as well as show and edit parameters of the system, as
below picture show.
For the detail operation, please refer to the introduction in section 6.
˙Routing
Press this button again, user can select one or several channels in below windows to assign the
signal to corresponding outputs.
For the detail operation, please refer to introduction in section 6.
48V Page
System Page
Bank Select
Left
Bank Select
Right
Long
Faders
All Faders
DCA
Assign
Channel
Gate
Comp
PEQ
GEQ
FX 1
FX 2
Routing
System
EQ
Ch01
DC48V
Ch08Ch02 Ch03 Ch04 Ch05 Ch06 Ch07
Ch09 Ch16Ch10 Ch11 Ch12 Ch13 Ch14 Ch15
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Sele cted Chan nel
FX1 FX2
Shor tcut To
Mete rs
Digital
Brightness Adjust
LCD
Knob
Load
Copy
Save
Default Page Setting
All Faders
Lock
Mixe r
48V
DCA
Routing
GEQ
Password
Setting
Fader
Calibration
Bank Select
Left
Bank Select
Right
Long
Faders
All Faders
DCA
Assign
Channel
Gate
Comp
PEQ
GEQ
FX 1
FX 2
Routing
System
EQ
Default Setting
Lock Matrix
Install Matrix
T1DSP_Firmware_1_V1.0
T1DSP_Firmware_2_V1.0
T3MCU_Firmware_1_V1.0
T0MCU_Firmware_2_V1.0
Curr ent Scene
Default
Default
Device Name: T2208
Default
Default
12
13
12
5