User Manual

Slide the fader or rotate Parameter Adjust knob
to adjust level of selected input channel.
DSP Control
6.14 Routing interface
You can select input channels of Main 1-20, FX1-2 and USB in and route them to output channels
of Main 1-20, Aux 1-8 and FX1-2. For example, below window shows Aux 1 routing function. In
this page, you can route input channels in LCD screen to Aux1 output.
In Main routing page, channel level can not be adjusted, but channel level in Aux and FX pages
are adjustable.
As the function of this button will be a little bit different in different control please notice the
notes that are shown on the LCD screen when operating.
Touch it to route input channel 1 to output AUX1 as an example. Please rotate
Parameter Adjust knob or slide long fader on the screen to change selected channel’s
audio level.
Touch PRE on the screen, it will switch to POST, and the background will illuminate.
The selected channel will derive its signals from all channels post-fader. If the button
has not been pressed and not illuminate, by default, the selected channel will derive
its signal from all channels pre-fader and all unaffected by the sending channel’s fader position.
This icon is a switch to change all channels to be POST or PRE.
If the selected channel was linked, they will change synchronous
in this page when you adjust them.
Parameter
CH01
OFF
CH17-18
CH01 CH08CH02 CH03 CH04 CH05 CH06 CH07
CH09 CH16CH10 CH11 CH12 CH13 CH14 CH15
CH19-20 FX1
PRE PRE
PRE
PRE
FX2
PRE
PRE
PRE
PRE
PRE
USB
PRE
PRE
PRE
PRE
PRE
PRE
PREPRE
PRE
PRE
PRE
All:
AUX1
Select
PRE
Bank Select
Left
Bank Select
Right
Long
Faders
All Faders
DCA
Assign
Channel
Gate
Comp
PEQ
GEQ
FX 1
FX 2
Routing
System
EQ
POST
OFF OFF OFF OFF OFF OFF OFF OFF
OFF OFF OFF OFF OFF
OFF OFF OFF OFF OFF
OFF OFF OFF
CH01
PRE
OFF
All:
POST
Parameter
CH01
OFF
38
6