User Manual

Software Update

Control

We will always update the T2208 software, please download the latest version from below sites:

www.topppro.com

Since function of T2208 will also change when you update the software, this manual can help

you familiar with the basic function, for the precision, please refer to the real T2208 digital mixer.

Note: When you update the firmware, all the parameters you had saved in the mixer may be

destroyed.

1. Main input channel select buttons

There are 18 select buttons Ch1-20 as you can see on the panel.

Press this button will route its channel to add DSP setting and assign its output. It will illuminate

as has been pressed and enabled. In DCA window, you can select group channels by this button.

2. Main input channel knobs

˙The knob Ch1-16 control the gain level of the channel's input.

Note: It is very important to properly set the level of the input gain to minimize noise and avoid

overload distortion.

˙The knob Ch17-20 control input level of the channels.

3. Main input signal clip indication

These LEDs beside input channel knobs indicate the input level of Channel1-20.

4. LED meters

The LED meters show the signal status, including the output level.

˙AUX1-8 & Main

Indicate the output level of AUX1-8 & Main. Please

be aware only AUX1-8 and Main button engaged

can light the corresponding meters.

˙AUX1-8 button

When the buttons are off, the meters above them

won’t light, while illuminated can light the meters.

˙Main/FX1/FX2/Solo meters

Indicate the input level of Main/FX1/FX2/Solo. Please be aware only FX1/FX2 or Solo meter button

engaged can light the corresponding meters.

5.1 Function buttons and knobs