User Manual

- Bypass
Click this button to bypass all signal to next block, if compressor bypass function is active the
button will illuminate. If it is not active,signal will be processed at this block and then flow to next
block.
- Flat COM
To flat all setting parameters to default.
- Delay
Delay here can engage and disengage the delay function for selected Channel. Move the slide
below it to set delay time. Only if delay function is active can set the delay time. If Bypass beside
it is enable, the parameter can not be adjusted.
5). Current input channel selection
Click channel button 1-8, corresponding background LED will light, which means current channel
is selected, you can set parameters on this channel.
6). Input channel mute control
Click it, the background LED will light, which means it enable mute function on current channel.
7). Input channel Meter control
Select the block and slide it to adjust current channel’s volume.
8). Input channel Meter dynamically indication
Dynamically indicate current channel’s input level meter.
9). Input channel Meter value display
The value will vary with slide moving.
10). Output channel control
Function in this area is similar to that to input channel. Please read carefully about input channel
introduction.
13
DSP Control
6