User Manual

- ENTER. Its function is as following:
1) Load Preset
Click UP/DOWN button to select preset, then Hold to press the “ENTER” button for about 3
seconds to recall the selected preset. After recalling successfully, the screen will display “Load
OK”.
2) Exit from Preset List Page
When the selected preset is empty, hold to press ENTER for 3s, no preset to load, the system
will exit from current page and return back to initial page.
3) Reset to defaults
Hold to press both PRESET and ENTER buttons for 8s to erase all memory settings, and reset to
defaults.
Note that whichever page it is, if hang it without any operation, the system will go back to initial
page about 5 seconds later.
3. Input Signal LED indicating
Indicate input connection status. When you connect this device to other host, the LEDs indicate
corresponding Mic port connection status at back panel.
LEDs indicate as below:
-CLIP(RED). It means current MIC input signal overload.
-SIG(GREEN). It means some signal input from current MIC port.
4. Input Channel MUTE Button
Press CH1-8 buttons, the corresponding background LED light, which means to mute signal from
selected channels.
5. Output Signal Indicating LED
Indicate output connection status. When you connect this device to other hosts, LEDs here
indicate corresponding XLR port connection status at back panel.
LEDs indicate as below:
-CLIP(RED). It means current XLR output signal overload.
-SIG(GREEN). It means some signal output from current XLR port.
6. Output Channel Select Button
Press CH1-8 buttons, the corresponding background LED light, which means signal can output
from selected channels.
7. Status LED Indication
LED indicating as below:
-COMM.(GREEN). Power on DLM808 and connect it with PC by router or CL-4, then open
DLM808’s software control page on PC, it lights if communication is common; while it turns off
if communication is fault.
-FAULT(RED). It lights when DSP runs fault, you can see fault information on LCD screen, see
details in section 1 about LCD Screen. At this time please check your device configuration.
6
Function Buttons and LED Indicators
4