User Manual

INDEX
INTRODUCTION
WIRE CONNECTIONS
FREQUENCY RESPONSE DIAGRAM
PANEL DESCRIPTION
8
RIGGING
7
WARRANTY
15
TECHNICAL SPECIFICATIONS
13
12
4
10
HOOKUP DIAGRAMS
5
QUICK START
6
3
* X 12A, X 15A are Active Speakers for
professional use , they can be used in following electromagnetic environment: residential,
commercial and light industrial, urban outdoors. They are the apparatusNot intended for
rack mounting.
* For X 12A, X 15A,the peak inrush current is 0.9A
*This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1)this device may not cause harmful interference , and (2)this device
must accept any interference received , including interference that may cause undesired
operation . Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
X
11
X
14