XCS 12A / XCS 15A
15
INTRODUCTION 4 HOOKUP DIAGRAMS 5 INSTALLATION TIPS QUICK START 6 7 RIGGING 8 PANEL DESCRIPTION 9 FREQUENCY RESPONSE DIAGRAM 10 WIRE CONNECTIONS TECHNICAL SPECIFICATIONS 11 12 WARRANTY 13 * XCS 12A, XCS 15A are Active Speakers for professional use , they can be used in following electromagnetic environment: residential, commercial and light industrial, urban outdoors. They are the apparatusNot intended for rack mounting. * For XCS 12A, XCS 15A, the peak inrush current is 0.
XCS 12 XCS 4 13
11 Technical Specifications 4 Hookup Diagrams Two speaker in stereo operation Model Active XCS 12A System Type 2-Way Active Vented Speaker /Bi-Amp. With DSP processor Transducer Low 12" Woofer, 2"voice coil Transducer Driver o o Horn Coverage H x V 1" Neodymium Driver, 1" Voice Coil 90 H x 60 V Frequency Response 50Hz-20KHz (-6dB) Crossover Frequency 1.6KHz - DSP Processor Max SPL AMP Power Output 125dB Max.
5 Installation Tips 1- Speakers should be placed in a position that allows for unobstructed sound projection. In many instances is beneficial for speakers to be elevated on tripod stands to achieve maximum dispersion and reach. 10 2- Use professional advice or service when hanging and installing speakers. Please take precautions to secure them to prevent them from falling and hurting someone. Care should be taken as to not damage the cabinet or its components.
9 Quick Start XCS 12A Make all initial connections with all the equipments powered off, and ensure that all the main volume controls are turned completely down. 6 1). Connect one side of the signal cable at your audio mixer into output left / right (with StereoJack or XLR) and the other side of the cable into the line input Stereo-Jack) of your active speaker cabinet. 2). Connect the power cord to mains. 3). Turn on your mixer first, then the active speaker cabinets. 4).
7 8 Panel Description Rigging The XCS series speaker cabinet also provides the suspension points for installation. (M10 1.5PH LENGTH: 30mm).
