Operator's Manual

13. Remove the lower compression spring. Disassemble the

ratchet ring from the ratchet gear ring by removing

three (3) locknuts and prying equally around the ratchet

ring (Fig. 26). Be extremely careful to prevent damage

to the mating surfaces.

Figure 26

1. Lower compression

spring

2. Locknuts

3. Rachet ring

14. For removal of the throwout handle (Fig. 27), O–ring

and finger, drive pin from throwout handle. Remove

throwout sleeve by turning counterclockwise.

Figure 27

1. Throwout handle

Note: When replacing O–ring, sleeve must be removed

(Fig. 28). Throwout sleeve need only be loosened for

removal of rachet ring gear.

Figure 28

1. O–ring 2. Sleeve

15. Lift out the upper compression spring. Remove rachet

gear ring from gear case.

16. Remove roller adjustment bolts and nuts from each side

of roller (Fig. 29).