Service Bulletin

Toro Customer Bulletin ROT #04-04 Page 1 of 3
Hover Pro
®
Operating Angles July 27, 2017
Customer Bulletin
Commercial Products
Rotaries #04-04
Hover Pro
®
Operating Angles
Product: Hover Pro
7/27/2017
Models:
02600
02601
02602
02603
02604
02605
02606
02609
02610
02611
02612
02615
Serial Number:
31200001 - 314999999
31200001 - 312999999
31200001 - 315999999
31200001 - 314999999
31200001 - 499999999
31200001 - 312999999
31200001 - 499999999
31300001 - 314999999
31400001 - 499999999
31300001 - 499999999
31500001 - 499999999
31400001 - 499999999
Situation:
Hover Pro units used beyond operating angles greater than 25° for the models 02600 / 02615 and
greater than 45° for models 02601, 02602, 02603, 02604, 02605, 02606, 02609, 02610, 02611, and
02612 will cause severe engine damage due to a lack of oil lubrication. Potential non-warrantable
damage could include seized valves, scored pistons and burned crank bearings.
Instructions:
Do not use these units beyond the recommended operating angles mentioned in the above
paragraph. Before operating on any slope, a site survey must be completed to determine
appropriate areas of operation.
Read, understand and follow the instructions listed below. Always check Engine-Oil level before
each use or daily.
Please contact your local Toro Commercial Products Distributor for more information on this
issue and if you need assistance in performing a site survey for slope angles. Reference
Service Bulletin Rotaries 04-04, “Hover Pro Operating Angles” when making your inquiry.