Operator's Manual

Figure5
Cuttingunits2and4only
1.Carriagebolt(M10x25
mm)
8.Locknut(M5)
2.Washer(M10)9.Rightdeectorbracket
3.Locknut(M10)10.Carriagebolt(M10x55
mm)
4.Screw(M5x16mm)11.Leftdeectorbracket
5.Reardelfector12.Cutting-unitassembly
6.Deectorspacer
13.Forward
7.Washer(3/16inch)
Important:Fitthesnapringtothedriveend.
8.Modifythecylinder-adjustmenthandwheelassemblies
oncuttingunit3totheangled-backpositionasfollows
(Figure6):
A.Removethenuts,bolts,andwashersfromthe
forwardholes.
B.Removethenuts,bolts,andwasherswhichattach
thehandwheelassembliestothecutting-unit
frame.
C.Removetheringboltclampnuts,washers,and
springwashers,andremovethehandwheel
assemblies.
D.Adjustthehandwheelassembliestoprovidethe
correctfasteningcentersandinstalltheminthe
alternativepositions.
E.Installallfastenersandtightenthemsecurely.
Figure6
1.Handwheelangledtorear
9.Secureeachcuttingunittothemowerinthecorrect
positionusingthepivotpin,2locknuts(M24),2
washers(M24),2nutcaps,apinretainer,2Belleville
washers(whereapplicable),asetscrew(M12x30mm),
andaspringwasher(Figure7).
Note:Cuttingunits2and4mountinfrontoftheir
respectivesuspensionarms.
Figure7
254-mmcuttingunit
1.Nutcap
6.Washer(M24)
2.Locknut(M24)7.Cutting-unitassembly
3.Screw(M12x30mm)
8.Forward
4.Springwasher(M12)
9.Bellevillewashers
5.Suppliedwiththecutting
unit
10.Pinretainer
11