Operator's Manual

Figure10
Cuttingunits2and6only
1.Washer(M10)7.Locknut(M5)
2.Locknut(M10)8.Cutting-unitassembly
3.Plate9.Forward
4.Roller-boxplate
10.Bolt(M10x90mm)
5.Carriagebolt(M10x55
mm)
11.Bumpstop
6.Rightdeectorplate
12.Handwheelinangled-back
position
Figure11
200mm(8inch)cuttingunitonly
1.Bumpstop5.Rollerboxplate
2.Locknut(M10)6.Carriagebolt(M10x55
mm)
3.Washer(M10)7.Bolt(M10x90mm)
4.Rollerbox
8.Installthewing-armlatch-plateassemblies(step6)to
therespectivecuttingunits,andsecureeachassembly
with4carriagebolts(M10x25),4washers(M10),and
4locknuts(M10).
9.Modifycuttingunits5,6,and7fromleft-handto
right-handcongurationasfollows:
A.Removeanddiscardtheprotectivecover.
B.Removethesnapring.
C.Removethecounterweighttogetherwiththe
O-ringandtittothenon-driveend.
D.Tightenthesocket-headcapscrewstoatorqueof
80N-m(59ft-lb).
E.Fitthesnapringtothedriveend.
Note:Refertothecuttingunitoperator’smanualfor
moreinformation.
13